Troubleshooting - laguna MBAND14BX110-175 Manual

bolt to pass through the table tilt hole, and the table can be moved to the maximum amount of
tilt (-7 degrees).
To adjust the table square to the blade.
1. Check that the stop bolt is in contact with the tilt-blanking disc.
2. Place an engineers square on the table top and bring up to the side of the blade.
3. Check if the blade is square to the table.
4. If adjustment is required loosen the lock nut on the tilt-stop bolt and adjust in the required
direction.
Note. Only adjust the tilt-stop
Tilt blanking disc Table tilt hole
bolt in very small steps.
5. Tighten the lock nut and re-
check the blade square to the
table.
6. If additional adjustment is
required repeat above steps.
Tilt stop bolt Tilt blanking disc

Troubleshooting.

Bandsaw will not start.
1. Check that the start switch is fully pulled out.
2. Check that the yellow safety plug is fully engaged.
3. Check that the electrical power cord is plugged into the power outlet.
4. Check that the electrical supply is on (reset the breaker).
5. Check that you have the correct power, 110V not 220V
The machine will not stop.
This is a very rare occurrence, as the machine is designed to be fail-safe. If it should occur
and you cannot fix the fault, seek professional assistance. The machine must be
disconnected from the power and never run until the fault has been rectified.
1. Stop switch faulty. Replace the stop switch.
51