Table of Contents
Advertisement
Fitting the optional light.
Fixing screws and cable clips
Light fitted in
position
Suggested cable route
Light plugged into
socket
The light is fitted to the top of the bandsaw as shown. The light is supplied with a three-pin
plug to suit either 110V or 220V depending on your machine votlage. The cable must be held
in position with the clips provided and positioned so that the cable is safe and will not in any
way come close to the blade or cabinet door. Above is the suggested cable route. Use the
sticky cable clamps to secure the cable along the top of the bandsaw. Ensure that the cable is
not over the vertical shaft hole, as it could be damaged when the shaft exits the hole.
25
Hide quick links:
Advertisement
Table of Contents
