laguna MBAND14BX110-175 Manual page 20

1. Support the bandsaw on wooden blocks.
2. Fit the swivel assembly to the back of the
bandsaw with the provided bolts.
3. Fit the front wheels to the front of the
bandsaw with the bolts provided and remove
the two rubber feet that are close to the front
wheels..
Note. Never operate the bandsaw with the
Rear swivel wheel
mobility kit engaged or the front wheel
assembly locking screw not engaged.
Front wheels Locking screw
Fitting the table.
Trunion clamp stud
Tilt stop bolt
It is possible to fit the table to the bandsaw with one person but far easier if you have two
people, one to lift the table and one to guide the trunion clamp studs.
20