Table of Contents
Advertisement
20. Blade tilt and tension mechanism.
The upper wheel is attached to the tilt and tension mechanism. This mechanism adjusts the
wheel so that the bandsaw blade can be adjusted for blade tracking. This is achieved by a
screwed handle at the back of the machine that pushes on the mechanism and adjusts the
axis of the wheel so that it runs true with the lower wheel. The second function is to tension
the blade, which is achieved by adjusting the upper flywheel vertically. A handle is located
below upper flywheel and, when rotated, will move the wheel up or down. The machine has a
quick-acting blade release mechanism that is located at the back of the machine and will
remove the tension from the blade to speed the removal and fitting of blades. The mechanism
has a spring, which helps to keep the tension constant as the blade expands and contracts
with the heat generated by the cutting action.
21. Electrical connection.
The bandsaw is provided with a cable and 110V
plug or 220v plug.
22. Identification.
There is a plate at the back of the machine listing all
the manufacturing data, including the serial number,
model and blade length.
Where to locate your Bandsaw.
Before you remove your bandsaw from the packaging, select the area where you will use your
machine.
There are no hard-and-fast rules for its location, but below are a few guidelines.
1. There should be an area at the front and back of the machine suitable for the length of
wood that you will be cutting. If you intend to use your saw for scrollwork, this may not be
important but should be considered at this stage.
2. Adequate lighting. The better the lighting, the more accurate and safely you will be able to
work
3. Solid floor. You should select a solid, flat floor, preferably concrete or
4. Close to power source and dust collection.
Unpacking your Bandsaw.
To unpack your machine, you will need tin snips, a knife and a wrench.
Note: The machine is heavy, and if you have any doubt about the described procedure, seek
professional assistance. Do not attempt any procedure that you feel is unsafe or that you do
not have the physical capability of
Using the tin snips, cut the banding that is securing the machine to the pallet (if fitted).
WARNING: EXTREME CAUTION MUST BE USED BECAUSE THE BANDING WILL
achieving.
something similar.
18
Hide quick links:
Advertisement
Table of Contents
