Remaining Back Plate Screws; Assembly Closer Sub-Assembly; Attach Wiring Harness To Chain Guard - Norton 6000 Series Installation And Instruction Manual

3

Remaining Back Plate Screws

4

Assembly Closer Sub-Assembly

A. i) Install Closer Sub-Assembly over screws in Step 3 with closer spring tube under
B. Secure screws for Closer Sub-Assembly from Step 3.
C. Secure top of Sub-Assembly to Blocking (for masonry, use anchors and spacers).
D. Connect wiring harnesses from Closer Sub-Assembly to Back Plate Assembly.
5

Attach Wiring Harness to Chain Guard

Using Cable Tie supplied in pack
with installation instructions, secure
wiring harness to loop on chain
guard just above the pinion.
Note: Wiring to be routed so it does
not interfere with pulley, is out of
door opening, and must route
beside chain guard, not over at
motor area, for cover to fit properly.
Copyright © 2015 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
"Closer"
Screws
i
ii
power supply and ii) slide Closer Sub-Assembly toward Hinge edge of door.
NOTE: Valves on door closer should be facing away from chain.
Connectors are keyed and only connect in one direction. Connectors will lock.
Concealed
Wiring Holes
See page 24
for removable
template.
i
ii
Wiring Not To
Interfere with
Pulley
Cable Tie
Page 6
A. Drill #7 and tap 1/4-20 Machine
Screws or Self Drilling Screws (7
places).
B. Install (7) 1/4-20 x 1" screws into
holes drilled in Step 3A. Leave
1/4" gap between bottom of
screw head of screws marked
"Closer" and frame.
C. Support between back plate and
wall is required.
From Closer
Sub-Assembly
Route Along
Wiring Not To
Side of Chain
Interfere with
Guard
Brake Assembly
on end of Motor
80-9360-1003-020 (08-15)
ASSA ABLOY
From Back
Plate Assembly
Wiring Harness