Electric Dogging Exit Device Wiring; Hard Wired Executive Function Wiring - Norton 6000 Series Installation And Instruction Manual

Electric Dogging Exit Device Wiring

Change Factory Pre-Wiring from Illustration A to Illustration B (more NO to NC)
A)
Electric Dogging Exit Device Wiring
Doors are normally closed and latched.
Ÿ
Turning key switch ON will apply power to
Ÿ
the exit device.
The first depression on the device
Ÿ
touchpad will electrically dog the device
for push/pull operation.
The door will now open automatically
Ÿ
when the wall switch is depressed.
The device will relatch during a power
Ÿ
failure or when the key switch is turned off.
The exit device allows egress at all times.
Ÿ
The exit device allows egress during
power failures.
Current draw at Power Outputs not to
Ÿ
exceed 1.3 amps.

Hard Wired Executive Function Wiring

Change Factory Pre-Wiring from Illustration A to Illustration B
A)
Hard Wire Executive Function
Doors are normally closed.
Ÿ
Activating switch will open door.
Ÿ
The door will remain in
Ÿ
indefinite hold open until
activating switch or is activated
a second time causing the door
to close.
Copyright © 2015 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
B)
ON / OFF
Key Switch
Reader, Key Switch, etc.
Momentary dry contacts)
B)
Page 16
ASSA ABLOY
24VDC Electric Dogging Exit
Device w/ Touch Bar Monitoring
(Yale and Corbin Russwin shown)
+ Touch Bar Monitor Switch
-
Wall Switch, Card
(Normally Open
Aux1
GND
Pres Det
GND
Aux2
GND
Door Toggle
GND
Aux1
Aux3
GND
Aux2
No Conn
Blow Open
Wall Switch, Card
Reader, Key Switch, etc.
(Normally Open
Momentary dry
contacts)
80-9360-1003-020 (08-15)