Electric Latch Retraction Exit Device Wiring/For Smoke Ventilation - Blow Open Function - Norton 6000 Series Installation And Instruction Manual

Electric Latch Retraction Exit Device Wiring
Change Factory Pre-Wiring from Illustration A to Illustration B
A)
Electric Latch Retraction Exit
Device Wiring
Ÿ Doors are normally closed and latched.
Activating switch will retract exit device
Ÿ
latch bolt and operator will open the door.
The door will closer after hold open time
Ÿ
delay has elapsed.
Exit device allows egress at all times. Exit
Ÿ
device allows egress during power failure.
Contact Tech Support for other devices or
Ÿ
manufacturer's instructions.
Electric Latch Retraction Exit Device Wiring for Smoke Ventilation - Blow Open Function
Change Factory Pre-Wiring from Illustration A to Illustration B
A)
Electric Latch Retraction Exit
Device Wiring - Blow Open
Ÿ Doors are normally closed and
latched.
Fire Alarm activation will retract exit
Ÿ
device latch bolt and door operator
will open door.
Door will remain open until the Fire
Ÿ
Alarm System has been reset.
Door Operator's main power input
Ÿ
must be wired into building's back-up
power system.
Exit device allows egress at all times.
Ÿ
Exit device allows egress during
power failure.
Copyright © 2015 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
B)
Controller -
15
782 (Yale)
16
7 8
B)
Controller -
15
782 (Yale)
16
7 8
Fire Alarm System
(Dry Contacts Only)
C
Page 17
ASSA ABLOY
120 VAC
-
Latch Retraction Exit Device
+
Yale and Corbin
Russwin shown
Wall Switch, Card
Reader, Key Switch, etc.
(Normally Open
Momentary dry contacts)
Aux1
GND
Pres Det
GND
Aux2
GND
Door Toggle
GND
Aux1
Aux3
GND
Aux2
No Conn
Blow Open
120 VAC
-
Latch Retraction Exit Device
+
Yale and Corbin
Russwin shown
NOTE: This application
must be approved by
local (AHJ) authority
NO
having jurisdiction.
80-9360-1003-020 (08-15)