Table of Contents
Advertisement
15
Set Home and Open Positions
A. With door closed and 3-position switch on end
of back plate in the "OFF" position, use joystick
to scroll down menu on LCD screen to "Home".
B. Push in on joystick to activate menu feature.
Display changes to "Set Close Limit".
C. Push in on joystick again, while door is still
closed, to set the Home or closed position.
Display changes to "Set Open Limit".
D. Open door to desired open position and push
in on joystick again. Display changes to
"Closing to Home".
E. Allow door to fully close again. Display
changes to "Home".
F. Scroll to Save Values and push in on joystick to
permanently save open and closed positions.
16
Connect Accessories and Make Necessary Controller Adjustments
17
Install Cover and Label
A. If using Surface Mount power input ONLY,
remove appropriate shaded area from cover,
see illustration below. Repaint cut edges as
necessary to prevent corrosion.
B. Place cover over unit and secure with (6) 6-32
screws taken out previously.
C. Attach label to cover as shown at right.
Cover surface
facing ceiling
2-7/8
Copyright © 2015 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
See Page 13 for Controller Adjustments
See Pages 14 - 20 for Accessory Wiring Instructions
See Page 21 for Troubleshooting Guide
Clearance for
Strain Relief
7/8
1-5/8
A)
C)
D)
½
½
½
Right Hand
Door
Page 11
ASSA ABLOY
B)
E)
½
Left Hand
Door
80-9360-1003-020 (08-15)
Hide quick links:
Advertisement
Table of Contents
