Table of Contents
Advertisement
IMPORTANT INSTALLATION INSTRUCTIONS
1) READ AND FOLLOW ALL INSTALLATION
INSTRUCTIONS.
2) Install only on a properly operating and balanced door. A
door that is operating improperly could cause severe
injury. Have qualified service personnel make repairs to
any hardware before installing the operator.
1a
Unpack Operator
A. Remove from box and unwrap operator.
B. Remove (6) screws holding cover (save to
be reused later) and remove cover.
1/4-20 Hex Bolts
1b
Initial Frame Holes
Left hand door illustrated.
A. Using template, locate and prepare holes in the frame.
B. Drill #7 and tap 1/4-20 Machine Screws or Self Drilling Screws (2 places).
Door Opening
Angle
85°
90°
95°
100°
105°
110°
Copyright © 2015 Yale Security Inc., an ASSA ABLOY Group company. All rights reserved.
Reproduction in whole or in part without the express written permission of Yale Security Inc. is prohibited.
Cable Tie
"A"
Dim "A"
4-1/8"
3-1/2"
2-7/8"
2-3/8"
2-0"
1-5/8"
3) Remove, or make inoperative, all locks (unless
mechanically and/or electrically interlocked to the
power unit) that are connected to the door before
installing the operator.
4) Do not connect the door operator to the source
power until instructed to do so.
C. Carefully remove cardboard insert.
D. Cut large cable tie, remove (2) 1/4-20 hex
bolts, and separate back plate and closer
sub-assembly.
21-5/16"
5/16"
Edge of Frame
or
C
of Hinge
L
Page 4
ASSA ABLOY
See page 24
for removable
template.
Frame Rabbet
80-9360-1003-020 (08-15)
Hide quick links:
Advertisement
Table of Contents
