Starter Motor Disassembly - Suzuki GN125F Service Manual

Measure the starter relay voltage at
the starter relay connectors (between
Y/G and W/B
button is pushed.
Voltage measured
Check the starter relay
(Refer to page 6-9)
Starter motor runs,
but does not start engine.

STARTER MOTOR DISASSEMBLY

Remove the starter motor. (Refer to page 3-7)
Disassemble the starter motor as shown.
O-ring
1
Housing end(outside)
2
Starter motor body
3
) when the starter
Amature shaft
4
Carbon brush
5
Housing end(inside)
6
ELECTRICAL
Not voltage
Incorrect
6-2
Faulty ignition switch
Faulty front brake light switch
Faulty rear brake light switch
Faulty starter button
Poor contact of connector
Open circuit in wiring harness
Faulty starting relay
Open circuit in wiring harness
Poor contact of connector
Faulty CDI unit
Faulty ignition coil
Faulty generator
Faulty starter clutch