ABB REF 610 Technical Reference Manual page 111

1MRS 755535
Feeder Protection Relay
Technical Reference Manual - ANSI Version
Table 4.1.17-8 Control parameters
Description
Resetting of relay state data
Time reading and setting
Date and time reading and setting
Type designation of the relay
Unlatching output contacts
Clearing targets and memorized
values and unlatching contacts
(master reset)
Resetting of trip lockout
Rated frequency
Time setting range for demand values
in minutes
Non-volatile memory settings
Time setting for disabling new trip
targets on the LCD
Testing the self-supervision
LED test for pickup and trip targets
LED test for programmable LEDs
Trip-circuit supervision
Remote control of setting group
Entering the SPA password for
settings
Changing the SPA password or
reinstating the password protection
Changing the HMI password
Clearing trip counters or AR counter V166
Restoring factory settings
Warning code
IRF code
Unit address of the relay
Data transfer rate (SPA), kbps
Parameter R, W, P Value
C W 0 = reset E50 and E51
1 = reset only E50
2 = reset only E51
4 = reset all events
including E51 except for
E50
T R, W SS.sss
D R, W YY-MM-DD HH.MM;SS.sss
F R REF 610
V101 W 1 = unlatch
V102 W 1 = clear and unlatch
V103 W 1 = reset
V104 R, W (P) 50 or 60 Hz
V105 R, W 0...999 min
V106 R, W 0...31
V108 R, W (P) 0...999 min
V109 W (P) 1 = the self-supervision
output contact is activated
and the READY target LED
pickups to blink
0 = normal operation
V110 W (P) 0 = pickup and trip LEDs off
1 = trip LED on, pickup
LED off
2 = pickup LED on, trip
LED off
3 = pickup and trip LEDs
on
V111 W (P) 0...255
V113 R, W 0 = not in use
1 = in use
V150 R, W 0 = setting group 1
1 = setting group 2
V160 W 1...999
V161 W (P) 1...999
V162 W 1...999
W (P) 1= clear trip counters
2= clear AR counters
V167 W (P) 2 = restore factory settings
for CPU
3 = restore factory settings
for DNP
V168 R
0...65535
V169 R
0...255
V200 R, W 1...254
V201 R, W 9.6/4.8
REF 610
1)
1)
111