Table of Contents
Advertisement
3. From the TPM Security option, select On.
4. Save the settings.
5. Restart your system.
6. Enter System Setup again.
7. On the System Setup Main Menu screen, click System BIOS > System Security Settings.
8. Select the TPM Advanced Settings option.
9. From the TPM2 Algorithm Selection option, select SHA256, then go back to System Security Settings screen.
10. On the System Security Settings screen, from the Intel TXT option, select On.
11. Save the settings.
12. Restart your system.
Control panel
Removing the control panel assembly
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Using the Phillips #2 screwdriver, remove the screw that secures control panel to the system.
2. Disconnect the control panel cable and the control panel USB cable from the system board.
CAUTION:
Do not use excessive force when removing the control panel cables as it can damage the
connectors.
3. Slide the control panel out of the system.
4. To remove the information tag, perform the following steps:
a. Locate and press the tabs on the information tag.
b. Push the information tag out of the slot to remove it from the control panel.
Figure 84. Removing the control panel assembly
NOTE:
Retain the information tag to replace it in the new control panel.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
85
Advertisement
Table of Contents
