Troubleshooting An Internal Usb Key - Dell PowerVault NX300 Hardware Owner's Manual

17 Reconnect the system to its electrical outlet, and turn on the system and
attached peripherals.
18 As the system boots, observe any error message that appears and the
diagnostic indicators on the front of the system.
19 If the memory problem is still indicated, repeat step 12 through step 18 for
each memory module installed.
If the problem persists after all memory modules have been checked,
see "Getting Help" on page 177.

Troubleshooting an Internal USB Key

CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Enter the System Setup program and ensure that the USB key port is
enabled. See "Integrated Devices Screen" on page 64.
2 Turn off the system and attached peripherals.
3 Open the system. See "Opening the System" on page 82.
4 Locate the USB key and reseat it. See "Internal USB Memory Key" on
page 100.
5 Close the system. See "Closing the System" on page 83.
6 Turn on the system and attached peripherals and check if the USB key is
functioning.
7 Repeat step 2 and step 3.
8 Insert a different USB key that you know works properly.
9 Close the system. See "Closing the System" on page 83.
10 Turn on the system and attached peripherals and check if the USB key is
functioning.
156
Troubleshooting Your System
Many repairs may only be done by a certified service technician. You