Openboot Configuration Parameters - Oracle Netra SPARC S7-2 Series Administration Manual

From the OpenBoot prompt, type:
■
From Oracle Solaris, type:
■
2. View the value for an individual OpenBoot parameter.
From the OpenBoot prompt, type:
■
where parameter is a valid OpenBoot parameter.
From Oracle Solaris, type:
■
where parameter is a valid OpenBoot parameter.
Related Information
"OpenBoot Configuration Parameters" on page 47
■
"printenv Output" on page 48
■

OpenBoot Configuration Parameters

Parameter
auto-boot-on-error?
auto-boot?
boot-command
eeprom
eeprom
Default Value Description
Controls whether or not the host attempts to boot after POST detects a
false
nonrecoverable error.
■ false – Host does not attempt to boot and stops at the ok prompt.
■ true – Host automatically attempts to boot.
Controls whether or not the host automatically boots after a system reset or
true
when the power is turned on.
■ true – Host automatically attempts to boot from the devices specified in
boot-device.
■ false – Host does not attempt to boot and stops at the ok prompt.
Specifies the command to be executed when auto-boot? is true. Valid boot
boot
commands:
■ boot – Boots kernel from devices specified in boot-device.
■ boot net – Boots kernel from the network.
■ boot cdrom – Boots kernel from the CD-ROM.
■ boot disk1:h – Boots from disk 1 partition h.
■ boot tape – Boots default file from tape.
printenv
parameter
printenv
parameter
Configuring Boot and Restart Behavior
View All OpenBoot Parameters
47