Scp File Transfer With Password Authentication - HP MSR2000 Configuration Manual

-rwxrwxrwx
-rwxrwxrwx
drwxrwxrwx
-rwxrwxrwx
drwxrwxrwx
# Download the pubkey2 file from the server and save it as a local file public.
sftp> get pubkey2 public
Fetching / pubkey2 to public
/pubkey2
# Upload a local file named pu to the server, save it as puk, and verify the result.
sftp> put pu puk
Uploading pu to / puk
sftp> dir
-rwxrwxrwx
-rwxrwxrwx
-rwxrwxrwx
drwxrwxrwx
drwxrwxrwx
-rwxrwxrwx
-rwxrwxrwx
sftp>
# Exit SFTP client view.
sftp> quit
<RouterA>

SCP file transfer with password authentication

Unless otherwise noted, the devices in the configuration examples are in non-FIPS mode.
If you configure an SCP server in FIPS mode, follow these guidelines:
• The modulus length of the key pair must be 2048 bits.
Do not generate a DSA key pair on the SCP server. Only RSA key pairs are supported.
•
Network requirements
As shown in
securely transfer files with Router B through Router A. Router B uses the password authentication method
and the client's username and password are saved on Router B.
Figure 68 Network diagram
Configuration procedure
1. Configure the SCP server:
# Generate the RSA key pairs.
1 noone nogroup
1 noone nogroup
1 noone nogroup
1 noone nogroup
1 noone nogroup
1 noone nogroup
1 noone nogroup
1 noone nogroup
1 noone nogroup
1 noone nogroup
1 noone nogroup
1 noone nogroup
Figure 68, Router A acts as an SCP client, and Router B acts as an SCP server. A user can
225 Aug 24 08:01 pubkey2
283 Aug 24 07:39 pubkey
0 Sep 01 06:22 new
225 Sep 01 06:55 pub
0 Sep 02 06:33 new2
100% 225
1759 Aug 23 06:52 config.cfg
225 Aug 24 08:01 pubkey2
283 Aug 24 07:39 pubkey
0 Sep 01 06:22 new
0 Sep 02 06:33 new2
283 Sep 02 06:35 pub
283 Sep 02 06:36 puk
243
1.4KB/s 00:00