Displaying And Maintaining Ssh; Stelnet Configuration Examples; Password Authentication Enabled Stelnet Server Configuration Example - HP MSR2000 Configuration Manual

Displaying and maintaining SSH

Task
Display the source IP address or source
interface information configured for the SFTP
client.
Display the source IP address or source
interface information configured for the Stelnet
client.
Display SSH server status information or session
information on an SSH server.
Display SSH user information on the SSH
server.
Display the public keys of the local key pairs.
Display the public keys of the SSH peers.

Stelnet configuration examples

Unless otherwise noted, the devices in the configuration examples are in non-FIPS mode.
If you configure an Stelnet server in FIPS mode, follow these guidelines:
The modulus length of the key pair must be 2048 bits.
•
Do not generate a DSA key pair on the Stelnet server. Only RSA key pairs are supported.
•
Password authentication enabled Stelnet server configuration
example
Network requirements
As shown in
and are assigned the user role network-admin for configuration management. The router acts as the
Stelnet server and uses password authentication. The username and password of the client are saved on
the router.
Figure 54 Network diagram
Stelnet client
192.168.1.56/24
Host
Configuration procedure
1. Configure the Stelnet server:
# Generate the RSA key pairs.
Figure 54, you can log in to the router through the Stelnet client (SSH2) that runs on the host
192.168.1.40/24
Command
display sftp client source
display ssh client source
display ssh server { session | status }
display ssh user-information [ username ]
display public-key local { dsa | rsa } public [ name
publickey-name ]
display public-key peer [ brief | name publickey-name ]
Stelnet server
Eth1/1
Router
226
Execute display commands in any view.