Security Association; Authentication And Encryption - HP MSR2000 Configuration Manual

Figure 40 shows how the security protocols encapsulate an IP packet in different encapsulation modes.
Figure 40 Security protocol encapsulations in different modes
Mode
Protocol
AH
ESP
AH-ESP

Security association

A security association (SA) is an agreement negotiated between two communicating parties called
"IPsec peers." An SA comprises a set of parameters for data protection, including security protocols (AH,
ESP, or both), encapsulation mode (transport mode or tunnel mode), authentication algorithm
(HMAC-MD5 or HMAC-SHA1), encryption algorithm (DES, 3DES, or AES), and shared keys and their
lifetimes.
An SA is unidirectional. At least two SAs are needed to protect data flows in a bidirectional
communication. If two peers want to use both AH and ESP to protect data flows between them, they
construct an independent SA for each protocol in each direction.
An SA is uniquely identified by a triplet, which consists of the security parameter index (SPI), destination
IP address, and security protocol identifier. An SPI is a 32-bit number that identifies an SA. It is transmitted
in the AH/ESP header.
An SA can be set up manually or through IKE.
Manual mode—Configure all parameters for the SA through commands. This configuration mode
•
is complex and does not support some advanced features (such as periodic key update), but it can
implement IPsec without IKE. This mode is mainly used in small and static networks or when the
number of IPsec peers in the network is small.
IKE negotiation mode—The peers negotiate and maintain the SA through IKE. This configuration
•
mode is simple and has good expansibility. In medium- and large-scale dynamic networks, HP
recommends setting up SAs through IKE negotiations.
A manually configured SA never ages out. An IKE-created SA has a lifetime, which comes in two types:
Time-based lifetime—Defines how long the SA can be valid after it is created.
•
• Traffic-based lifetime—Defines the maximum traffic that the SA can process.
If both lifetime timers are configured for an SA, the SA becomes invalid when either of the lifetime timers
expires. Before the SA expires, IKE negotiates a new SA, which takes over immediately after its creation.

Authentication and encryption

Authentication algorithms
IPsec uses hash algorithms to perform authentication. A hash algorithm produces a fixed-length digest for
an arbitrary-length message. IPsec peers respectively calculate message digests for each packet. The
Transport
IP AH Data
IP ESP Data ESP-T
IP AH ESP Data ESP-T
Tunnel
IP AH IP Data
IP ESP IP Data
IP AH ESP IP Data
138
ESP-T
ESP-T