HP MSR2000 Configuration Manual page 78

[Device-luser-network-localuser] quit
# Configure the idle cut function to log off any online user that has been idle for 20 minutes.
[Device-luser-localuser] authorization-attribute idle-cut 20
[Device-luser-localuser] quit
5. Configure a RADIUS scheme:
# Create the RADIUS scheme radius1 and enter its view.
[Device] radius scheme radius1
# Specify the IP addresses of the primary authentication and accounting RADIUS servers.
[Device-radius-radius1] primary authentication 10.1.1.1
[Device-radius-radius1] primary accounting 10.1.1.1
# Configure the IP addresses of the secondary authentication and accounting RADIUS servers.
[Device-radius-radius1] secondary authentication 10.1.1.2
[Device-radius-radius1] secondary accounting 10.1.1.2
# Specify the shared key between the access device and the authentication server.
[Device-radius-radius1] key authentication simple name
# Specify the shared key between the access device and the accounting server.
[Device-radius-radius1] key accounting simple money
# Exclude the ISP domain name from the username sent to the RADIUS servers.
[Device-radius-radius1] user-name-format without-domain
[Device-radius-radius1] quit
NOTE:
The access device must use the same username format as the RADIUS server. If the RADIUS server includes
the ISP domain name in the username, so must the access device.
6. Configure the ISP domain:
# Create the ISP domain aabbcc.net and enter its view.
[Device] domain aabbcc.net
# Apply the RADIUS scheme radius1 to the ISP domain, and specify local authentication as the
secondary authentication method.
[Device-isp-aabbcc.net] authentication lan-access radius-scheme radius1 local
[Device-isp-aabbcc.net] authorization lan-access radius-scheme radius1 local
[Device-isp-aabbcc.net] accounting lan-access radius-scheme radius1 local
[Device-isp-aabbcc.net] quit
7. Configure 802.1X:
# Enable 802.1X globally.
[Device] dot1x
# Enable 802.1X on port Ethernet 1/1.
[Device] interface ethernet 1/1
[Device-Ethernet1/1] dot1x
[Device-Ethernet1/1] quit
# Enable MAC-based access control on the port. (Optional. MAC-based access control is the
default setting.)
[Device] interface ethernet 1/1
[Device-Ethernet1/1] dot1x port-method macbased
67