HP MSR2000 Configuration Manual page 207

# Set the local identity to the FQDN name www.routera.com.
[DeviceA-ike-profile-profile1] local-identity fqdn www.routera.com
# Configure a peer ID with the identity type of FQDN name and the value of www.routerb.com.
[DeviceA-ike-profile-profile1] match remote identity fqdn www.routerb.com
[DeviceA-ike-profile-profile1] quit
# Create an IKE proposal named 10.
[DeviceA] ike proposal 10
# Specify the authentication algorithm as HMAC-SHA1.
[DeviceA-ike-proposal-10] authentication-algorithm sha
# Specify the RSA authentication method.
[DeviceA-ike-proposal-10] authentication-method rsa-signature
[DeviceA-ike-proposal-10] quit
# Create an IPsec policy named map1, with the sequence number as 10, and the IPsec SA setup
mode as IKE.
[DeviceA] ipsec policy map1 10 isakmp
# Specify the remote IP address 2.2.2.2 for the IPsec tunnel.
[DeviceA-ipsec-policy-isakmp-map1-10] remote-address 2.2.2.2
# Reference IPsec transform set tran1 for the IPsec policy.
[DeviceA-ipsec-policy-isakmp-map1-10] transform-set tran1
# Reference ACL 3101 to identify the traffic to be protected.
[DeviceA-ipsec-policy-isakmp-map1-10] security acl 3101
# Specify IKE profile profile1 for the IPsec policy.
[DeviceA-ipsec-policy-isakmp-map1-10] ike-profile profile1
[DeviceA-ipsec-policy-isakmp-map1-10] quit
# Apply the IPsec policy map1 to interface Ethernet 1/1.
[DeviceA-Ethernet1/1] ipsec apply policy map1
[DeviceA-Ethernet1/1] quit
# Configure a static route to the subnet where Host B resides.
[DeviceA] ip route-static 10.1.2.0 255.255.255.0 2.2.2.2
2. Configure Device B:
# Assign an IP address to each interface. (Details not shown.)
# Create an IPsec transform set named tran1.
<DeviceB> system-view
[DeviceB] ipsec transform-set tran1
# Set the packet encapsulation mode to tunnel.
[DeviceB-ipsec-transform-set-tran1] encapsulation-mode tunnel
# Use the ESP protocol for the IPsec transform set.
[DeviceB-ipsec-transform-set-tran1] protocol esp
# Specify the encryption and authentication algorithms.
[DeviceB-ipsec-transform-set-tran1] esp encryption-algorithm aes-cbc-128
[DeviceB-ipsec-transform-set-tran1] esp authentication-algorithm sha1
[DeviceB-ipsec-transform-set-tran1] quit
# Create a PKI entity named entity2.
[DeviceB] pki entity entity2
196