HP MSR2000 Configuration Manual page 161

Hide thumbs Also See for MSR2000:
Table of Contents

Advertisement

An IKE-based IPsec policy can reference up to six IPsec transform sets. During an IKE negotiation,
IKE searches for a fully matched IPsec transform set at the two ends of the IPsec tunnel. If no match
is found, no SA can be set up, and the packets expecting to be protected will be dropped.
The remote IP address of the IPsec tunnel is required on an IKE negotiation initiator and is optional
on the responder. The remote IP address specified on the local end must be the same as the local
IP address specified on the remote end.
For an IPsec SA established through IKE negotiation:
The IPsec SA uses the local lifetime settings or those proposed by the peer, whichever are smaller.
The IPsec SA can have both a time-based lifetime and a traffic-based lifetime. The IPsec SA expires
when either lifetime expires.
Directly configuring an IKE-based IPsec policy
Step
1.
Enter system view.
2.
Create an IKE-based IPsec
policy entry and enter its view.
3.
(Optional.) Configure a
description for the IPsec
policy.
4.
Specify an ACL for the IPsec
policy.
5.
Specify IPsec transform sets
for the IPsec policy.
6.
Specify an IKE profile for the
IPsec policy.
Command
system-view
ipsec { ipv6-policy | policy }
policy-name seq-number isakmp
description text
security acl [ ipv6 ] { acl-number |
name acl-name } [ aggregation |
per-host ]
transform-set
transform-set-name&<1-6>
ike-profile profile-name
150
Remarks
N/A
By default, no IPsec policy exists.
By default, no description is
configured.
By default, no ACL is specified for
the IPsec policy.
An IPsec policy can reference only
one ACL.
By default, the IPsec policy
references no IPsec transform set.
By default, the IPsec policy
references no IKE profile, and it
uses the IKE parameters configured
in system view for negotiation.
An IPsec policy can reference only
one IKE profile, and it cannot
reference any IKE profile that is
already referenced by another
IPsec policy or IPsec policy
template.
For more information about IKE
profiles, see "Configuring IKE."

Advertisement

Table of Contents
loading

This manual is also suitable for:

Msr3000Msr4000

Table of Contents