Installing And Removing The Memory Modules; Installing Memory Modules; Removing Memory Modules - Supermicro X10DRG-Q User Manual

2-5

Installing and Removing the Memory Modules

Note: Check Supermicro's website for recommended memory modules.
Exercise extreme care when installing or removing DIMM

Installing Memory Modules

1. Insert the desired number of DIMMs into the memory slots, starting with
P1-DIMMA1. (For best performance, please use the memory modules of the
same type and speed in the same bank.)
2. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
BMC
BIOS
LEDM1
IPMI CODE
BIOS
MAC CODE
LICENSE
BAR CODE
X10DRG-Q
Rev.1.01
JBAT1
PCH
JBT1
USB 6 (3.0)
SP1
USB 2/3
FANB
AUDIO_FP
JSPDIF_IN1
3. Align the key of the DIMM module with the receptive point on the memory
slot.
4. Align the notches on both ends of the module against the receptive points on
the ends of the slot.
5. Use two thumbs together to press the notches on both ends of the module
straight down into the slot until the module snaps into place.
6. Press the release tabs to the locking positions to secure the DIMM module
into the slot.
Press both notches straight
down into the memory slot at
the same time.

Removing Memory Modules

Press both notches on the ends of the DIMM module to unlock it. Once the DIMM
module is loosened, remove it from the memory slot.
CAUTION
modules to prevent any possible damage.
LAN2 LAN1 USB 0/1 USB 4/5(3.0)
LED1
COM1
VGA
LAN
FAND FANC
CTRL
IPMI_LAN
CPU2
CLOSE 1st
OPEN 1st
CPU1
CLOSE 1st
OPEN 1st
JVR1
2-13
Chapter 2: Installation
Notches
Release Tabs