Cmos Clear; Watch Dog Enable/Disable - Supermicro X10DRG-Q User Manual

X10DRG-Q Motherboard User's Manual

CMOS Clear

JBT1 is used to clear CMOS. Instead of pins, this "jumper" consists of contact pads
to prevent accidental clearing of CMOS. To clear CMOS, use a metal object such
as a small screwdriver to touch both pads at the same time to short the connection.
Note 1. For an ATX power supply, you must completely shut down the
system, and then short JBT1 to clear CMOS.
Note 2. Clearing CMOS will also clear all passwords.

Watch Dog Enable/Disable

Watch Dog (JWD1) is a system monitor that will
reboot the system when a software application
hangs. Close pins 1-2 to reset the system if an
application hangs. Close pins 2-3 to generate a
non-maskable interrupt signal for the application
that hangs. See the table on the right for jumper
settings. Watch Dog must also be enabled in the
BIOS.
BMC
BIOS
B
BIOS
LICENSE
X10DRG-Q
Rev.1.01
A
JBAT1
PCH
JBT1
USB 6 (3.0)
USB 2/3
FANB
AUDIO_FP
JSPDIF_IN1
LAN2
LED1
VGA
LAN
FAND FANC
CTRL
LEDM1
IPMI CODE
MAC CODE
BAR CODE
CPU1
CLOSE 1st
OPEN 1st
SP1
JVR1
2-34
Pin#
1-2
2-3
Open
LAN1 USB 0/1 USB 4/5(3.0)
COM1
IPMI_LAN
CPU2
CLOSE 1st
OPEN 1st
Watch Dog
Jumper Settings
Definition
Reset (default)
NMI
Disabled
A. Clear CMOS
B. Watch Dog Enable