I-Sgpio1/2 & S-Sgpio Headers; Standby Power Header - Supermicro X10DRG-Q User Manual

I-SGPIO1/2 & S-SGPIO Headers
Three SGPIO (Serial Link General Purpose
Input/Output) headers are located on the
motherboard. I-SGPIO1 supports I-SATA 0-3,
I-SGPIO2 supports I-SATA 4/5. S-SGPIO is
used for S-SATA 0-3. See the table on the
right for pin definitions.

Standby Power Header

The +5V Standby Power header is located at
JSTBY1 on the motherboard. See the table
on the right for pin definitions. (You must also
have a card with a Standby Power connector
and a cable to use this feature.)
BIOS
D
LICENSE
A
C
B
PCH
FANB
LAN
BMC
CTRL
BIOS
LEDM1
IPMI CODE
MAC CODE
BAR CODE
X10DRG-Q
Rev.1.01
JBAT1
JBT1
USB 6 (3.0)
SP1
USB 2/3
AUDIO_FP
JSPDIF_IN1
2-29
Chapter 2: Installation
I-SGPIO1/2 & S-SGPIO Headers
Pin Definitions
Pin# Definition
1 NC
3 Ground
5 Load
7 Clock
Note: NC= No Connection
Standby PWR
Pin Definitions
Pin# Definition
1 +5V Standby
2 Ground
3 No Connection
A. I-SGPIO1 (for I-SATA0-3)
B. I-SGPIO2 (for I-SATA4/5)
C. S-SGPIO (for S-SATA0-3)
D. Standby PWR
LAN2 LAN1 USB 0/1
LED1
VGA
FAND FANC
CPU2
CLOSE 1st
OPEN 1st
CPU1
CLOSE 1st
OPEN 1st
JVR1
Pin# Definition
2 NC
4 Data
6 Ground
8 NC
USB 4/5(3.0)
COM1
IPMI_LAN