Connecting Cables; Power Connectors - Supermicro X10DRG-Q User Manual

X10DRG-Q Motherboard User's Manual
2-7

Connecting Cables

Power Connectors

A 24-pin ATX main power supply con-
nector (JPWR1), two 8-pin CPU power
connectors (JPWR2, JPWR3), and a
4-pin connector (JPWR4) are located on
the motherboard. These power connec-
tors meet the SSI EPS 12V specification
and must be connected to your power
supply to provide adequate power to the
system. See the tables on the right for pin
definitions.
Warning: To avoid damaging your moth-
erboard and components, please use a
power supply that supports a 24-pin, two
8-pin and one 4-pin power connectors. Be
sure to connect the 24-pin and the 8-pin
power connectors to your power sup-
ply for adequate power delivery to your
system. The 4-pin power connector is op-
tional; however, Supermicro recommends
that this connector also be plugged in for
optimal power delivery.
FANB
LED1
LAN
BMC
CTRL
BIOS
LEDM1
IPMI CODE
BIOS
MAC CODE
LICENSE
BAR CODE
X10DRG-Q
Rev.1.01
JBAT1
PCH
JBT1
USB 6 (3.0)
SP1
USB 2/3
AUDIO_FP
JSPDIF_IN1
2-26
ATX Power 24-pin Connector
Pin Definitions (JPW1)
Pin# Definition
13 +3.3V
14 -12V
15 COM
16 PS_ON
17 COM
18 COM
19 COM
20 Res (NC)
21 +5V
22 +5V
23 +5V
24 COM
12V 8-pin Power Connec-
tor Pin Definitions
Pins
1 through 4
5 through 8
A. JPWR1: 24-pin main PWR (Req'd)
B. JPWR2: 8-pin Processor PWR (Req'd)
C. JPWR3: 8-pin Processor PWR (Req'd)
D. JPWR4: 4-pin Processor PWR (Req'd)
LAN2 LAN1 USB 0/1 USB 4/5(3.0)
COM1
VGA
FAND FANC
IPMI_LAN
CPU2
CLOSE 1st
OPEN 1st
CPU1
CLOSE 1st
OPEN 1st
JVR1
Pin # Definition
1 +3.3V
2 +3.3V
3 COM
4 +5V
5 COM
6 +5V
7 COM
8 PWR_OK
9 5VSB
10 +12V
11 +12V
12 +3.3V
Definition
Ground
+12V
(Required)
D
C
B
A