4.10 Bluetooth module
4.10 Bluetooth module
Removing the Bluetooth module
To remove the Bluetooth module, follow the steps below and refer to Figure 4-16.
1. Remove the following screw securing the Bluetooth module.
2. Disconnect the Bluetooth flat cable from both the Bluetooth module and connector
3. Disconnect the Bluetooth antenna cable from the Bluetooth module.
Installing the Bluetooth module
To install the Bluetooth module, follow the steps below and refer to Figure 4-16.
1. Connect the Bluetooth antenna cable to the connector on the Bluetooth module.
2. Connect the Bluetooth flat cable to both the Bluetooth module and the connector
3. Install the Bluetooth module along the guide and secure it with the following screw.
PORTEGE R200 Maintenance Manual (960-519)
Downloaded from
www.Manualslib.com
•
M2×3C
CN4400 on the system board.
Bluetooth flat cable
Figure 4-16 Removing the Bluetooth module
CN4400 on the system board.
•
M2×3C
manuals search engine
S-FLAT HEAD screw
M2×3C S-FLAT HEAD
CN4400
S-FLAT HEAD screw
4 Replacement Procedures
x1
Bluetooth module
Bluetooth antenna cable
x1
[CONFIDENTIAL]
4-27