TP-Link TL-WR841N User Manual page 66

Chapter4 Configure
Default Gateway - Display the default gateway in colon-hexadecimal notation
provided by your ISP.
Renew - Click Renew to renew the 1Pv6 parameters from your ISP.
Release - Click Release to release the 1Pv6 parameters from your ISP.
Get 1Pv6 DNS Server Automatically - If your ISP does not give you any DNS 1Pv6
address, keep the default selection Get 1Pv6 DNS Server Automatically, and the
DNS servers will be assigned from ISP dynamically.
Primary 1Pv6 DNS - Enter the DNS 1Pv6 address in colon-hexadecimal
notation provided by your ISP.
Secondary 1Pv6 DNS -Enter another DNS 1Pv6 address in colon-hexadecimal
notation provided by your ISP.
Use the following 1Pv6 DNS Servers - If your ISP gives you one or two DNS 1Pv6
addresses, select Use the following 1Pv6 DNS Servers and enter the Primary
1Pv6 DNS and Secondary 1Pv6 DNS in the corresponding fields.
Ill
Note:
If you get "Address not found error" when you access a web site, it is likely that your DNS servers are set up
improperly. You should contact your ISP to get DNS server addresses.
Static 1Pv6
WANSetup
Enable 1 Pv6:
0
WAN Connection
Type-
~ I St- a tic - I P\.6 -~ T
1
1 Pv6 Address:
Default Gateway: (Optonal)
MTU Size (in bytes):
~ (The
default is 1500, do not change unless necessary.)
Pnmary ONS:
Secondary ONS:
(Opt onal)
1Pv6 Address - Enter the 1Pv6 address in colon-hexadecimal notation provided
byyour ISP.
Default Gateway - Enter the default gateway in colon-hexadecimal notation
provided by your ISP.
MTU Size (in bytes) - The normal MTU (Maximum Transmission Unit) value for
most Ethernet networks is 1500 Bytes. For some ISPs, you may need to modify
the MTU. But this is rarely required, and should not be done unless you are sure
it is necessary for your ISP connection.
Primary DNS - Enter the DNS 1Pv6 address in colon-hexadecimal notation
provided by your ISP.
61