TP-Link TL-WR841N Quick Installation Manual

Quick

Installation Guide

300Mbps Wireless N Router
TL-WR841N / TL-WR841ND

1. Connect the Hardware

1 Power off the modem,
and remove the backup
battery if any.
Power Off
INTERNET
Note: If your Internet comes via an Ethernet cable from the wall instead of any DSL/Cable/Satellite modems, please connect the Ethernet cable directly to the router's WAN port.

2. Configure the Router

Method 1 Via Web Browser
1
Connect your computer to the router (Wired or Wireless).
Wired
WPS/
ON/OFF POWER WAN 1 2 3 4 RESET
2
Open a web browser on the computer and configure the router according to the following main clues.
a
Enter http://tplinkwifi.net in the address bar.
http://tplinkwifi.net
c
Select your WAN Connection Type, or click Auto-Detect
if you are unsure what your connection type is. Click Next
and follow the instructions to continue.
Quick Setup-WAN Connection Type
Auto-Detect
Dynamic IP (Most Common Cases)
Static IP
PPPoE/Russian PPPoE
L2TP/Russian L2TP
PPTP/Russian PPTP
Back
2 Connect the modem to the Internet
port on your router using an Ethernet
cable.
WIFI
ON/OFF
Ethernet cable
Type in admin for both the user name and password
and click Login.
Note: If the login window does not appear, please refer to FAQ->Q1.
d
Verify or change the wireless network settings, and click Next.
Note: You may customize your wireless network name and password.
If you do so, please note down the new ones.
Quick Setup- Wireless
Wireless Network Name:
Wireless Password:
Next
Typical Connection
3 Power on the modem,
wait for 2 minutes and
then power on the router.
INTERNET
WPS/ WIFI
ON/OFF POWER WAN 1 2 3 4
RESET ON/OFF
Wireless
Connect wirelessly by using
the default network name
Or
(SSID) and password
printed on the product label
at the bottom of the router.
admin
admin
Login
Copyright © 2014 TP-LINK Technologies Co., Ltd. All rights reserved.
TP-LINK_XXXX
Region:
Warning:
Wireless Security:
XXXXXXXX
Back Next
INTERNET
Modem
ON/OFF
4
Power On
INTERNET
ON/OFF POWER WAN 1 2 3 4 Power
Power On
On
b
Click Next to continue the Quick Setup.
Quick Setup
To continue, please click the Next button.
To exit, please click the Exit button.
Exit
e
Click Finish to complete the setup.
Quick Setup-Finish
Congratulations!
Back Finish
Wireless N Router
WPS/ WIFI
POWER WAN 1 2 3 4 RESET ON/OFF
Check the following LEDs to
ensure the hardware connection
is correct.
WPS/ WIFI
WLAN WAN
RESET ON/OFF
Flashing On/Flashing
Next
Enjoy!
Now your wired and
wireless devices can
connect to the Internet !