Dhcp; Dhcp Settings - TP-Link TL-WR841N User Manual

Chapter4 Configure
Wireless Security - You can configure the security of the guest network.
Access Time - During this peroid the wireless devices can access the guest
network.
~ Note:
The range of bandwidth for guest network is calculated according to the setting of Bandwidth Contrai on the
Bandwidth Control
>
Control Settings page.
4. 6.
DHCP
By default, the DHCP (Dynamic Host Configuration Protocol) Server is enabled and the
router acts as a DHCP server; it dynamically assignsTCP/IP parameters to client devices
from the IP Address Pool. You can change the settings of DHCP Server if necessary, and
you can reserve LAN IP addresses for specified client devices.
4. 6. 1.
DHCP Settings
1. Visit http://tplinkwifi.net, and log in with the username and password you set for
the router.
2. Go to DHCP
>
DHCP Settings.
3. Specify DHCP server settings and click Save.
DHCP Settings
DHCP Server:
Start IP Address:
l
192.168.0.100
End IP Address:
l
192.168.0.199
Address Lease Time:
l
120
1
minutes (1-2880 min utes, the default value is 120)
Default Gateway:
1192.168_ 0_ 11 8
Default Domain: (Optional)
Primary
ONS:
1
O _ O_ O _ O
1
(Optional)
~===~
Setondary
ONS 10.0.0.0 1
(Optional)
Save
• DHCP Server - Enable or disable the DHCP server. If disabled, you must have another
DHCP server within your network or else you must configure the computer manually.
• Start IP Address - Specify an IP address for the DHCP Server to start with when
assigning IP addresses. 192.168.0.1 OO is the default start address.
• End IP Address - Specify an IP address for the DHCP Server to end with when assigning
IP addresses. 192.168.0.199 is the default end address.
• Address Lease Time - The Address Lease Ti me is the amount of time a network user
will be allowed to connect to the router with the current dynamic IP Address. When
35