Table of Contents
Advertisement
Using the shelf manager CLI
Basic shelf manager CLI Commands
Change IP address of the primary Shelf Manager
Display the shelf manager firmware version
List all FRUs in the chassis
List all sensors on a FRU
List only sensors that are outside of established thresholds
Display sensor data for a FRU
Display the FRU information for a FRU
Change the speed for a fan tray
Display the contents of the system event log (sel)
Clear the system event log (sel)
FortiGate-5060 Chassis Guide
01-400-129494-20110912
http://docs.fortinet.com/
•
Feedback
From the FortiGate-5050 chassis shelf manager CLI you can view system information,
FRU information and sensor data with the following basic commands. If your chassis has
two shelf managers, you must connect to the active shelf manager to access sensor data.
The default IP address of the primary shelf manager is 192.168.0.2. Use the following
command to change this IP address.
# clia setlanconfig <channel> ip <ip_address>
<channel> is the shelf manager channel and can be 1 or 2. <ip_address> is the new
IP address in dotted decimal notation. For example:
# clia setlanconfig 1 ip 192.168.0.2
# clia version
To display a complete list of all information enter version with no other parameters.
# clia fru
# clia sensor <IPMB_address>
# clia sensor -t
# clia sensordata <IPMB_address> <sensor_number>
# clia fruinfo <IPMB_address> <FRU_id>
# clia setfanlevel <IPMB-address> <FRU_id> <speed>
<speed> can be from 0 to 14.
# clia sel
# clia sel clear
Basic shelf manager CLI Commands
31
Advertisement
Table of Contents
