Air Filter - Fortinet FortiGate-5060 Chassis Manual

FortiGate-5060 chassis

Air filter

FortiGate-5060 Chassis Guide
01-400-129494-20110912
http://docs.fortinet.com/ • Feedback
Table 5: Telco alarm connector pin assignment
Pin Name
1 AMIR+
2 AMIR-
3 AMAR+
4 AMAR-
5 ACNO
6 ACNC
7 ACCOM
8 AMINO
9 AMINC
10 AMINCOM
11 AMANO
12 AMANC
13 AMACOM
14 APRCO
15 APRCOM
Shield Shelf-GND
The FortiGate-5060 chassis includes a front replaceable air filter. The filter provides 80%
dust arrestance and meets the requirements of the Telcordia Technologies Generic
Requirements GR-78-CORE specification. The filter must be installed for the
FortiGate-5060 chassis to operate normally. If the air filter is not locked into place the air
filter presence switch causes an alarm.
Air filters should be inspected regularly. If dirty or damaged, the filter should be disposed
of and replaced.
The air filter can be removed using the air filter handle on the front of the FortiGate-5060
chassis. To install a new filter, push the new filter into the guide rails at each side of the
shelf until the filter locks into place.
Description
MinorReset+
MinorReset-
MajorReset+
MajorReset-
CriticalAlarm - NO
CriticalAlarm - NC
CriticalAlarm - COM
MinorAlarm -NO
MinorAlarm - NC
MinorAlarm - COM
MajorAlarm - NO
MajorAlarm - NC
MajorAlarm - COM
PwrAlarm - NO
PwrAlarm - COM
Shelf Ground
Air filter
15