DCS RDV2 Installation Instructions Manual page 13

The ranges have shipping weights varying from 420 to 630lbs less approx. 50lbs after
●
removal of packing material. It is recommended that the oven door(s), pan supports
and front kick panel be removed to facilitate handling, reducing the weight and to pass
through some doorways:
With the door(s) removed, a 29 1/2" wide opening is required. Without removing the
●
door, a 32" wide opening is required.
The range is held to the skid in the front by either two bolts (RGV2/RDV2 models) or
●
two L-brackets (RGCV2 models), located behind the kickpanel; and at the back by either
two bolts (RDV2 models) located behind the rear metal panel, or two L-brackets (RGV2/
RGCV2 models) located on the bottom flange of the range back.
After removing the bolts and brackets, the range must be lifted and removed from the
●
skid.
Due to the weight, a dolly with soft wheels should be used to move this unit. The weight
●
must be supported uniformly across the bottom, as shown.
The range should be transported by a dolly close to its final location.
●
The floor under the legs should be protected (wood strips, carpet, paneling, etc.) before
●
pushing the unit back into its final position.
To remove the kick panel
Remove the two screws at the top and pull forward.
●
To refit the kick panel
Replace the kick panel by reversing the procedure and securing the two screws either
●
side at the top.
IMPORTANT!
It is important that the two screws retaining the kick panel are secure to prevent
accidental access to live electrical components and wires.
9
REMOVE FROM SKID & PLACE ON DOLLY
!0
TO REMOVE AND REFIT THE KICK PANEL
Left Rear Shipping
Left Rear
RGCV2
Shipping Screws
Screws
model shown
22"
Range must
be uniformly
supported
on long braces
Kick Panel
Kick Panel (may vary)
13