DCS RDV2 Installation Instructions Manual page 11

Important notes
All ranges come fitted standard with with either an Integral Flat Vent Trim or an Angled Vent Trim (RGCV2-305 models only)
●
There are three different backguards available for purchase:
●
Range Mount Low Backguard
●
Wall Mount High Backguard with Low Shelf
●
Wall Mount High Backguard with High Shelf, also supplied with an Angled Vent Trim.
●
For installations against non-combustible* surfaces only, you may install the range without a backguard or choose any of the three backguards.
●
For installations close to combustible surfaces (above the cooking surface), without a backguard, there must be a minimum 6" (152mm) clearance
●
(see Scenario 2 or 7 opposite)
For installations immediately against combustible surfaces (above the cooking surface), you must purchase and fit the Wall Mount High Backguard
●
High Shelf and Angled Vent Trim (see Scenario 5 opposite)
The cooking surface must sit flush or above the adjacent countertop level.
●
* Non-combustible surfaces:
as defined in 'National Fuel Gas Code' (ANSI Z223.1, Current Edition). Clearances from non-combustible materials
are not part of the ANSI Z21.1 scope and are not certified by UL. Clearances of less than 6" (152mm) must be
approved by the local codes and/or by the local authority having jurisdiction.
BACKGUARD MODEL NUMBERS
WALL
RANGE
MOUNT HIGH
RANGE MOUNT LOW
BACKGUARD
BACKGUARD
LOW SHELF
BGRV2-1230 BGRV2-3030
30" models
BGRV2-1236 BGRV2-3036
36" models
48" models BGRV2-1248 BGRV2-3048
Note: For more information on Backguard installation, refer to the separate instructions provided with your backguard.
Backguard Installation Instructions can also be downloaded from our website, www.dcsappliances.com
7
INSTALLATION SCENARIOS AND USE OF BACKGUARDS
WALL
MOUNT HIGH BACKGUARD
BACKGUARD WIDTH
HIGH SHELF
BGRV2-3030H 29 7/8" (759mm)
BGRV2-3036H 35 7/8" (911mm)
BGRV2-3048H 47 7/8" (1216mm)
11