Rigol MSO1000Z Series User Manual page 239

Chapter 15 Accessibility Setting
Network Status
Connect the oscilloscope to your local area network using a network cable. The
network interface of the oscilloscope is at the rear panel. The oscilloscope will give
different prompts according to the current network connection status.
Net Config Success！

Acquire IP...

IP Conflict!

Unconnected!

DHCP Fail!

Read Status Fail!

IP Configuration Type
The configuration type of the IP address can be DHCP, auto IP or static IP. In
different IP configuration type, the configuration mode of the network parameters
(such as the IP address) is different.
DHCP
Press Configure and use
type. When DHPC is valid, the DHCP server in the current network will assign the
network parameters (such as the IP address) for the oscilloscope.
Auto IP
Press Configure and use
type. When the auto IP type is valid, disable DHCP manually, Gate and DNS are
added to the right side of the screen and users can define the gateway and DNS
server address of the oscilloscope. In auto IP mode, the oscilloscope will get the IP
address ranging from 169.254.0.1 to 169.254.255.254 and the subnet mask
255.255.0.0 automatically according to the current network configuration.
Static IP
Press Configure and use
this type. When this type is valid, disable DHCP and auto IP manually, IP Address,
MSO1000Z/DS1000Z User's Guide
nd Quality Products Online at:
to select "DHCP". Then press down
to select "Auto IP". Then press down
to select "Static IP". Then press down
GlobalTestSupply
www.
to select this
to select this
to select
.com
sales@GlobalTestSupply.co
RIGOL
15-3