Rigol MSO1000Z Series User Manual page 221

Chapter 14 Store and Recall
3. Waves
Save the main setting information (e.g. "On/Off" states of the channels, vertical
scale and horizontal scale) and waveform data of all enabled channels (analog
channel and digital channel) to the external memory in "*.wfm" format. When
the waves file is loaded, the system will set the oscilloscope based on its existing
saved setting information of the oscilloscope and recall all the waveform data.
When the loading is complete, the oscilloscope will be in the "STOP" state.
Under such situation, you can adjust the waveform display by changing the
setting (such as the horizontal scale and vertical scale) of the oscilloscope; or
you can adopt the one-key measurement or cursor measurement to measure
the waveform parameters.
Note:


4. Setups
Save the settings of the oscilloscope to internal or external memory in "*.stp"
format. The stored settings can be recalled.
5. CSV
Save the screen waveform data of all enabled channels (analog channel and
digital channel) or the memory data of the specified enabled channels to the
external memory in "*.csv" format. You can specify the file name and the saving
directory and save the corresponding parameter file (*.txt) under the same
directory using the same file name. This parameter file is the same as the
"Parameters" function. The recall of CSV and parameter files is not supported.
After selecting this type:
Press DataSrc to select "Screen" or "Memory". After selecting "Memory", press
Channel to select the desired channel
can be selected).
Press Param to enable or disable the parameter save function.
Press Sequence to choose whether to add sequence numbers for the waveform
points in the CSV file. You can select "ON" or "OFF" and the default is "ON"
(namely add the sequence number).
6. Parameters
Save the parameters of the screen waveform to the external memory in "*.txt"
format. The parameter storage contains the system information (such as the
MSO1000Z/DS1000Z User's Guide
nd Quality Products Online at:
waveforms will be displayed on the screen.)
The reading and saving operations of the file in ".wfm" format can only be
completed on the oscilloscope.
If you set the oscilloscope to be in the "RUN" state, the oscilloscope will
start over the waveform sampling. (That means, the loaded waveform data
will be cleared.)
GlobalTestSupply
www.
(Note: Only channels currently enabled
.com
RIGOL
14-3
sales@GlobalTestSupply.co