Rigol MSO1000Z Series User Manual page 142

RIGOL
Delay and Phase
Source1
Source2
Source 1 and source 2, the same as source A and source B in the measurement
setting menu can be any channel of CH1-CH4 or D0-D15. For the setting method,
please refer to the introduction in "Measurement Setting".
1. Delay
source 2. Negative delay indicates that the selected rising edge of source 1
occurred after that of source 2.
2. Delay
source 2. Negative delay indicates that the selected falling edge of source 1
occurred after that of source 2.
3. Phase
the period of source 1, expressed in degree. The calculation formula is as shown
in equation (6-1).
4. Phase
the period of source 1, expressed in degree. The calculation formula is as shown
in equation (6-1).
The phase calculation formula:
Wherein,
represents "Phase
Phase
represents "Delay
Delay
represents the period of source 1
Period 1
6-28
nd Quality Products Online at:
Figure 6-4 Delay and Phase
1→2: the time difference between the rising edges of source 1 and
1→2: the time difference between the falling edges of source 1 and
1→2: phase difference calculated according to "Delay
1→2: phase difference calculated according to "Delay
Phase =
1→2" or "Phase
1→2" or "Delay
GlobalTestSupply
www.
Chapter 6 MATH and Measurement
Period
Delay
Delay
°
×360
Period1
1→2"
1→2"
MSO1000Z/DS1000Z User's Guide
1→2" and
1→2" and
(6-1)
.com
sales@GlobalTestSupply.co