Rigol MSO1000Z Series User Manual page 151

Chapter 6 MATH and Measurement
BY: the Y value at cursor B. Y value takes the channel GND of CH1 as reference.

Its unit is the same as that of the current signal source.
BX-AX: the horizontal difference between cursors A and B.

BY-AY: the vertical difference between cursors A and B.

|dX|: when the horizontal unit is set to "s", |dX| represents the time difference

between cursor A and cursor B; when the horizontal unit is set to "Hz", |dX|
represents the frequency difference between cursor A and cursor B.
1/|dX|: the frequency difference between cursor A and cursor B.

When the measurement source is set to LA, the form of the measurement results is
as shown in the figure below if the horizontal unit is set to "s".
AX: the X value at cursor A. X value takes the trigger position as reference.

D15-D0: display the logic level values at cursor A (D15-D0 from left to right) in

hexadecimal forms. If the digital channel is currently turned off, it will be
denoted by "*".
BX: the X value at cursor B. X value takes the trigger position as reference.

D15-D0: display the logic level values at cursor B (D15-D0 from left to right) in

hexadecimal forms. If the digital channel is currently turned off, it will be
denoted by "*".
For the introductions of BX-AX, |dX| and 1/|dX|, refer to the introductions in "When
the measurement source is set to CH1-CH4 or MATH".
If needed, please refer to the following steps to modify the parameters of manual
cursor measurement.
1. Select Cursor Type
Press Select to select "


2. Select Measurement Source
Press Source to select the waveform of the analog channels (CH1-CH4), math
operation results (MATH) or LA waveform for measurement.
Note:
MSO1000Z/DS1000Z User's Guide
nd Quality Products Online at:
: the X cursors are a pair of vertical solid (cursor A)/dotted (cursor B)
lines and are usually used to measure time parameters.
: the Y cursors are a pair of horizontal solid (cursor A)/dotted
(cursor B) lines and are usually used to measure voltage parameters.
Note: When the current measurement source is LA, the cursor type is
" " and cannot be set.
Only channel currently enabled can be selected.
GlobalTestSupply
www.
" or " ".
.com
sales@GlobalTestSupply.co
RIGOL
6-37