Parameter Setting - Mitsubishi FREQROL-SFJ Maintenance Manual

(2) Parameter setting

Set parameters with READY signal (SET) turned off.
Motor speed is displayed
o
(Fig. 1) when alarm does
not occur.
0 Each time @ switch is pressed, ADDRESS and
Selecting the
Note: If display in ADD
Ex.:
o Display in DATA section can be incremented
o E;tB;zzsing a switch, the set data can be
o After the desired data has been set, press
DATA alternate.
by pressing morH switch.
address is displayed in DATA section.
section does not
change, but DATA
press w switch t;
DATA to ADDRESS.
In example shown
in Fig. 1, ADD dis-
play changes to S
pressed, and to SZ when the switch is
pressed again (Fig. 2).
or decremented by pressing @*or @ switch.
to set desired value for DA
switch on card SFJ-CA1 or turn off and
en on the power to reset FR-SFJ.
Now data setting (parameter setting) has been
completed.
19 -
ADD DATA
Fig. 1 Motor speed
display
Data at the
Fig. 2
(Data at address
in **.)
when c l UP switch is