Embroidery Foot Height - ELNA eXpressive920 Service Manual

Embroidery foot height

The clearance between the embroidery foot and the surface of the needle plate should be in the range of 1.7 mm to 1.9 mm
when the presser bar is lowered.
Reverse
stitch button
Start/Stop button
Embroidery foot
1.8 mm
Mechanical Adjustment
⇒
Surface of
needle plate
To adjust:
1. Attach the embroidery foot (P).
2. Turn the power switch ON while pressing the Start/Stop
button and the Reverse stitch button to enter the factory
setting mode.
Press "Foot Up/Down" key.
* The presser foot will rise when it is lowered.
3. Press "Offset" key. The "Offset" key changes to "Adjust".
4. Press "1.7 mm". The embroidery foot will be lowered.
5. If the clearance is less than 1.7 mm, press the "–" key to
raise the foot until the clearance reaches 1.8 mm.
6. If the clearance is more than 1.9 mm, press the "+" key
to lower the foot until the clearance decrease to 1.7 mm
or less, then press the "–" key to raise the foot until the
clearance reaches 1.8 mm.
NOTE:
Always finish adjustment by pressing the "–" key.
7. Press "Set" key.
The embroidery foot height will be memorized.
Press "X" key to exit the adjusting mode.
42