Adjusting Height Of Embroidery Foot P - ELNA 9500 Service Manual

9500

Adjusting Height of Embroidery Foot P

Space between the needle plate and the bottom surface of the Foot (P) should be
0.7 to 1.5 mm, when the needle bar is at its lowest position.
Needle plate
e
(A)
w
q
Needle
1 Set the pressure dial at "2" and remove the
top cover.
2 Lower the needle bar and lower the presser bar
lifter.
3 Insert the 1.2 mm Thickness gauge
the Embroidery Foot (P)
4 While pressing the Pressure bar actuator
against the upper shaft cam, loosen the Screw (A)
and push it down to the direction of arrow, then
tighten Screw (A) again.
5 Reattach the rear cover.
(Set the Pressure dial at "3".)
NOTE: After this adjustment, must perform "Foot
sensor adjustment". (See page 32)
24
q
between
w
and the needle plate.
e
down