Adjusting Presser Foot Height And Alignment - ELNA eXperience 620 Service Manual

ADJUSTING PRESSER FOOT HEIGHT
When the presser foot is raised, the clearance between the presser foot and the needle plate should
be 5.7 to 6.3 mm.
1. Remove the face cover and raise the presser foot.
Loosen the setscrew to adjust presser foot height (6.0 mm) and presser foot alignment.
2. Tighten the setscrew firmly.
3. Attach the face cover.
Setscrew 4x8
[HEIGHT OF PRESSER FOOT]
Presser foot
Needle plate
AND ALIGNMENT
5.7 to 6.3 mm
Feed dog
10
MODEL: eXperience 620
Presser foot lifter
PRESSER FOOT ALIGNMENT
Should be
parallel