L2Tpv3 Client Setup - D-Link NetDefendOS User Manual

B. Enable transparent mode on the inner interface where the protected network is located.
Example 9.18. L2TPv3 Client Setup
In this example, an L2TPv3 Client object called my_l2tpv3_client is to be created. This will connect
with the L2TPv3 server with the IP address l2tpv3_server_ip.
This client will connect to the server over an IPsec tunnel called l2tpv3_ipsec_tunnel. It is assumed
that the tunnel has already been defined.
Command-Line Interface
A. First, define the L2TPv3Client object:
gw-world:/> add Interface L2TPv3Client my_l2tpv3_client
B. Next, enable transparent mode on the protected interface If1:
gw-world:/> set Interface Ethernet If1 AutoSwitchRoute=Yes
Web Interface
A. First, define an L2TPv3 Client object:
1. Go to: Network > Interfaces and VPN > L2TPv3 Client > Add > L2TPv3 Client
2. Now enter:
• Name: my_l2tpv3_client
• Inner IP Address: inner_client_ip
• Local Network: If1_net
• Pseudowire Type: Ethernet
• Protocol: UDP
• Remote Endpoint: l2tpv3_server_ip
3. Click OK
B. Next, enable transparent mode on the protected interface If1:
1. Go to: Network > Interfaces and VPN > Ethernet
2. Select the If1 interface
3. Select the option Enable transparent mode
4. Click OK
IP=inner_client_ip
LocalNetwork=If1_net
PseudowireType=Ethernet
Protocol=UDP
RemoteEndpoint=l2tpv3_server_ip
749
Chapter 9: VPN