Ipsec Vpn Between Client And An Internal Network; Creating A Roaming Users Tunnel - D-Link DFL-1100 Manual

Hide thumbs Also See for DFL-1100:

Table of Contents

IPSec VPN between client and an internal network

In the following example users can connect to the

main office internal network from anywhere on the

Internet. Communication between the client and the

internal network takes place in an encrypted VPN

tunnel that connects the DFL-1100 and the roaming

The example shows a VPN between a roaming

VPN client and the internal network, but you can also

create a VPN tunnel that uses the DMZ network. The

networks at the ends of the VPN tunnel are selected

when you configure the VPN policy.

Follow these steps to add a roaming users tunnel.

Step 1. Go to Firewall and VPN and choose Add new.

Step 2. Enter a Name for the new tunnel in the name field. The name can contain

numbers (0-9) and upper and lower case letters (A-Z, a-z), and the special characters -

and _. No other special characters and spaces are allowed.

Step 3. Specify your local network, or your side of the tunnel, for example

192.168.1.0/255.255.255.0, in the Local Net field. This is the network your roaming VPN

clients should be allowed to connect to.

Step 4. Choose authentication type, either PSK (Pre-shared Key) or Certificate-based. If

you choose PSK make sure the clients use exactly the same PSK.

Step 5. As Tunnel Type choose Roaming User.

Click the Apply button below to apply the change or click Cancel to discard changes.

users across the Internet.

Table of Contents