D-Link NetDefendOS User Manual page 861

Chapter 13: Advanced Settings
• LogAll – Logs all packets in the connection.
Default: Log
Log Connection Usage
This generates a log message for every packet that passes through a connection that is set up in
the NetDefendOS state-engine. Traffic whose destination is the NetDefend Firewall itself, for
example NetDefendOS management traffic, is not subject to this setting.
The log message includes port, service, source/destination IP address and interface. This setting
should only be enabled for diagnostic and testing purposes since it generates unwieldy volumes
of log messages and can also significantly impair throughput performance.
Default: Disabled
Dynamic Max Connections
Allocate the Max Connection value dynamically.
Default: Enabled
Max Connections
This setting applies if Dynamic Max Connections above is disabled. Specifies how many
connections NetDefendOS may keep open at any one time. Each connection consumes
approximately 150 bytes RAM. When this setting is dynamic, NetDefendOS will try to use as
many connections as is allowed by product.
Default: 8192
861