Codes; Programming And User Codes; Replacing Batteries - Schlage LE162 Installation Instructions & User Manual

PROGRAMMING AND USER CODES

All locks are pre-programmed with a programming code and two user codes. The programming
code and user codes can be changed at any time.
All pre-programmed codes can be found on the yellow sticker on the front of the Installation
Instructions that come with the lock. An identical label is also located on the inside of the
internal lock body.
Programming Code (six digits)
• Used to manually program the lock using
the keypad.
• Used to put the lock into enrolment mode.
• Can only be changed by manually using the
keypad. See Manual Programming Functions
on the inside front cover for more information.
• CANNOT be used to unlock the lock.
• CAN be used to take a lock out of vacation mode
at the keypad. See Vacation Mode Function, on
page 18 for more information.
• If you change your programming code and then
forget it, you can reset your lock back to factory
settings. See Restoring Factory Settings
Functions on page 19 for more information.
User Codes (four digits)
• Used to unlock the lock.
• May be added and deleted manually, using the keypad in programming mode or through
the solution providers interface (refer solution provider for details.)
REPLACING THE BATTERIES
Remove battery cover, remove old AA batteries and/or 9 volt battery. Replace batteries with new,
high-quality batteries, and replace the battery cover.
CAUTION: Lock will set to DEADLOCK mode once the batteries are replaced. Door will lock
internally and externally. To unlock externally enter a user code, from internally use the key.
16