My Codes; Best Practices; Default Codes Locations - Schlage BE468 series User Manual

eNABLe/DISABLe Auto-LoCk
Press Enter
6 Digit
Programming Code
temPoRARILy DISABLe Auto-LoCk*
Press
4-8 Digit User Code
* Door should be locked to begin
ReStoRe Auto-LoCk
Press
Relock the deadbolt using
the thumbturn.

my CoDeS

Use the table on page 8 to record Programming and User Codes that you program into the lock.
• The Programming Code can be any combination of six numbers entered into the keypad to put the
lock in Programming Mode.
• The first 4 - 6 numbers (depending on User Code Length) must be different from all of the User
Codes currently in the lock.
• One Programming Code is programmed into the lock by default. This code can be found on the
stickers, one on the back of the Interior Assembly and one on the back of this guide.
user Codes
• A User Code can be any combination of 4 - 8 digits entered into the keypad to unlock the lock.
• The first 4-6 digits must be different from the first 4-6 digits of the Programming Code.
• Two User Codes are programmed into the lock by default. These two codes can be found on the
stickers, one on the back of the Interior Assembly and one on the back of this guide.

Best Practices

• Give each person their own unique User Code.
• Change User and Programming Codes periodically to ensure security.

Default Codes Locations

Codes are located on the back of the Interior Assembly.
»
DO NOT remove the sticker from the back of the Interior Assembly! If you lose your Programming Code, you can reset your lock back to
these default codes.
Press
Enable: 1 Blink + 1 Beep
Disable: 2 Blinks + 2 Beeps
Within 5 seconds, manually
lock and unlock the deadbolt
using the thumbturn.
2 Blinks +
2 Beeps
1 Blink +
1 Beep
»
Use a pencil to enter the codes
in the boxes so you can easily
change them later.
»
Up to 30 User Codes can be
stored in the lock at one time.
7