Schlage LE162 Installation Instructions & User Manual page 14

5. Install exterior lock body.
Weather Seal
5.1 Remove the cylinder driver from its packet and attach it to its nodule located
near the bottom of the exterior lock body. Spin the cylinder driver until the
lip is under the screw.
5.2 Adjust/spin the 'female' cylinder driver until it aligns with the 'male' counterpart
on the internal body. The crescent hole should be vertical.
5.3 Ensure the weather seal is attached to the external body before mounting.
5.4 Connect the plug from the interior body, that was threaded under the latch earlier,
to the socket on the exterior body.
5.5 Align the lock bodies on either side of the door and prepare to mount the lock.
12
Vertical
Cylinder Driver