Table of Contents
Advertisement
ODS/Modal
8.7.5
Redo a measurement
You can store one set of data per measurement point/direction. However, you can
overwrite a measurement.
Procedure
1.
2.
8.7.6
Copy ODS/Modal data
Copy data stored on one measurement point/direction to another measurement point/
direction. Use this option if you could not mount a sensor at a location, and you assume
the vibration is the same for other points.
Procedure
1.
2.
3.
4.
8.8
Display the data for a measurement point
1.
2.
3.
4.
5.
8.9
Print an ODS/Modal plot to AMS Machinery
Manager
Prerequisites
•
186
From the ODS/Modal main menu, press F9 Point Search or use the arrows on the
keypad to go to a measurement point.
Press Enter to collect data.
Select the measurement point to copy.
From the ODS/Modal main menu, press ALT > F9 Copy Data.
Press F10 Paste From to paste the data to another measurement point.
Press Enter.
Activate a job.
From the ODS/Modal main menu, use the up and down arrow keys or press F9 Point
Search to go to the desired measurement point.
Press F7 Display Data.
If the measurement point does not have any stored data, this option is unavailable.
Review or modify the plots as necessary.
Press Enter.
On the analyzer, press Home > ALT > F2 General Setup > F6 Set Print Mode and ensure the
default print mode is set to Send to PC.
Advertisement
Table of Contents
