Table of Contents
Advertisement
Introduction to the analyzer
2.4
Attach the shoulder strap
1.
2.
2.5
Battery pack
A rechargeable Lithium-Ion battery pack powers the analyzer. A typical charge should last
for more than 8 hours of continuous use. The analyzer displays a low-battery warning
when the remaining charge reaches a set level; the default is 15 percent. If the battery
pack fully discharges, you do not lose any data or settings.
You do not need to discharge or calibrate the battery pack. The hardware optimizes
battery pack performance. Contact technical support if you experience any problems or
for instructions to replace the battery pack.
WARNING!
Use only Emerson battery packs with the CSI 2140. The analyzer will not function if a non-
Emerson battery pack is used. Lithium-Ion batteries have very specific charging requirements.
Emerson power supplies and chargers are designed to work with the Emerson Lithium-Ion
battery pack. Using battery packs other than approved Emerson battery packs could not only
void the warranty, but could also be hazardous.
8
Figure 2-3:
Release the stand
Press and hold the button on the strap connector, and insert it into the connectors
on the sides of the analyzer or the CSI 2140 Four-Channel Input Adapter, if attached.
To release the strap, press and hold the button on the connector and then pull.
Advertisement
Table of Contents
