Table of Contents
Advertisement
24
Operating the pole-mounted pruner | Tool cleaning and maintenance
EN
After the cut, remove the saw from the cutting point at full speed. Release the switch and stop
the saw. Before turning the pole down to the ground make sure the saw chain stopped
moving.
Never cut near other persons to prevent their injury.
12. TOOL CLEANING AND
MAINTENANCE
Cleaning the chainsaw body
Keep the chainsaw body clean. When cleaning, use a soft cloth soaked in a soap water. Use this
cloth to carefully clean the chainsaw body.
Guide bar maintenance
Most problems with the guide bar occur as a result of uneven wear and tear. Uneven wear
and tear occurs mostly due to incorrect chain sharpening and incorrect adjustment of
the raker. If the bar is worn out unevenly, the guiding groove is getting wider (See Figure).
Consequently, it results in chain rattling and rivets falling off. It is impossible to make straight
cuts with the saw. In such case replace the guide bar by a new one.
Before chain sharpening, always check the state of the guide bar. Using worn out or
damaged guide bar is very dangerous. Using worn out or damaged guide bar will result in
chain damage. Cutting using such tool will also be significantly more difficult and laborious.
FZP 6005-E
Advertisement
Table of Contents
