Table of Contents
Advertisement
Setup procedure
(1) As shown in the figure above, connect the reference resistor to the GL820's input terminals.
(2) Leave the GL820 turned on for at least
minutes
after wiring.
(3) After entering the System Setup mode, open the Setup menu as shown below.
Specify the AMP Setup conditions as shown below.
Mode
CH
(4) Move the cursor to the "Execute Setup" position as shown below.
GL820-UM-251-9370
30
minutes. And leave the GL820 turned on for at least
:Setup3 (RTD temp.)
:CH 20
4-13
4. SETUP PROCEDURES
10
Hide quick links:
Advertisement
Table of Contents
